If you didn't enter our website via the
index page. Please click here 
Additional notes to Conner CTD8000 Technical Page:
CONNER PEREGRINE CTD8000 Rev A
The first production run (Rev. A) of Conner peregrine CTD8000 tape drives do not
have a dip-switchbank to enable you to alter the factory default settings. The tape drives
are despatched with the following settings:
| SCSI ID = 0 | COMPRESSION ON = 8Gb |
| PARITY OFF | MRS MODE ON |
| SELF TEST OFF | INQUIRY STRING ON or OFF DEPENDENT ON DRIVE |
So the Rev. A drive has with the SAME default settings as a Conner CTD8000 with dip switches. If you need to alter these settings, you must look to the 16 pin jumper block at the rear of the drive.
 16 pin jumper block. |
pins 1&2, 3&4, 5&6 |
SCSI ID See table below. |
 16 pin jumper block. |
|
| pins 9&10 |
No jumper = 8Gb. Compression. |
|||
| pins 11&12 |
A jumper sets. Active SCSI Termination. |
|||
| pins 15&16 |
A jumper sets. SCSI Termination Power. |
|||
| pins 8&10 |
A jumper enables. Self Test. |
SCSI ID SELECTION |
SCSI ID |
||
| Pins 5&6 | Pins 3&4 | Pins 1&2 | |
NO JUMPER |
NO JUMPER |
NO JUMPER |
0 |
| NO JUMPER | NO JUMPER | JUMPERED | 1 |
| NO JUMPER | JUMPERED | NO JUMPER | 2 |
| NO JUMPER | JUMPERED | JUMPERED | 3 |
| JUMPERED | NO JUMPER | NO JUMPER | 4 |
| JUMPERED | NO JUMPER | JUMPERED | 5 |
| JUMPERED | JUMPERED | NO JUMPER | 6 |
| JUMPERED | JUMPERED | JUMPERED | 7 |
You will notice that there isn't any pin pairs to alter the default settings of Parity and MRS Mode. If you ever need to change these settings, you must download - Switch.zip.
